4/29/2023 0 Comments Battery isolator relay napa![]() snmpwalk -v -c community -o filename -p 161 -r 3 -t 10 IP-address startOID where: l -v is the version of SNMP to use: SNMPv1, SNMPv2c, or SNMPv3 l -c community indicates the SNMP read-only community string (see note for SNMPv3) l -e if present, means to proceed to the end of the MIB l -n num-OIDs if present, indicates the number of OIDs to display (-e and -n are mutually exclusive) l -o filename is the name of a SQLite-format file saved in the InterMapper Settings/Temporary directory. The InterMapper server implements a simple snmpwalk facility in its debug mode. You can also execute SNMPWalk as a server command, and include specific arguments as described below. In some cases this may not be sufficient. 160 -Ĭhapter 8: Troubleshooting Probes Debugging with the SNMPWalk Command InterMapper provides a simple SNMPWalk command, available from the Monitor menu, that allows you to perform an SNMPWalk on a specified OID. ![]() But when InterMapper requested that row, it learned it was not present.) Consequently, InterMapper displays the "noSuchName" value. The index (.10) indicates which row to retrieve. (The OID 1.3.6.1.2.1.2.2.1.2 is the ifDescr for an interface on a device. Open the Debug window, and look for entries in this format. This probably means that there is an error with the OID for one of the device variables. Error: When I build a custom probe, the status window shows "" for certain values. In this example, the proper OID should have a "2" in place of the "7" that's there. Look at the subsequent lines to find item 3, and check that OID very carefully. ![]() Errors with Custom Probes Note that the first line above shows a "noSuchName" error for index 3. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |